CONTINUOUSWAVE

Jim--you have answered all my questions. You did confirm that the drop cable does not have power. As you said most drop cables from devices do not have power. I have seen only one situation that power did come down the cable, and I had to use the isolator device. Thanks again for a great job in answ...

The information that you provided above will be helpful. I will be setting up the NMEA-2000 network power on the house battery that is isolated from the starting. All the electronics that are currently on the NMEA-2000 are also isolated. When I power the [ICON Pro RPM gauge] with the violet wire, wi...

I found this diagram [ please see the complete diagram reproduced below--jimh ] in one of you earlier posts. The NMEA-2000 network is powered by the control harness item 13. When I connect the ICON PRO RPM gauge, do I use the isolating device to keep the power from the gauge isolated from the engine...

I understand the old information talks about the gateway device. I just discovered that the new ICON II rigging does not require the gateway. I have searched the internet to try and find documents that show a typical installation with the newer ICON II installation. All I seem to find is the older I...

I was reading an article that talked about the E-TEC G2 ICON II system. When you do the rigging you no longer need the gateway module to connect to the NMEA-2000 network. I have looked at all the articles that [jimh] has written using the gateway. When I look at the Evinrude information on the inter...