CONTINUOUSWAVE

I bought a used Lowrance LMF-400 from a buddy [in order to be able to configure the Lowrance NMEA-2000 temperature sensors] because [the local Evinrude] dealer did not have [a Lowrance multi-function display to use to configure them]. To configure and heat-test all three sensors with the LMF-400 too...

The [analogue inputs on the Evinrude ICON 7.0 CTS] can also be used for oil along with the water tank levels you listed.

[Thanks for the emendation--I added it to the earlier mention above--jimh]

After many phone calls to BRP technical services, I finally found somebody who knew how to configure these temperature sensors to [operate on the network with ] the ICON 7.0 CTS. EVDIAG will see the sensors on the network when installed, but it provides no way to configure them. You must use a Lowra...

I made got to the dealer. [The dealer found the fuel tank level NMEA-2000 convertor, part number] 0768916, was bad. I had checked the resistive sending unit on the fuel tank; and the resistance readings were correct. I figured [the cause of all the problems] had to be a bad [NMEA tank level converto...

Evinrude has temperature sensors with part number 0764183 with the description “sea water kit w/tee." These sensors are used for water, air, and livewell temperature with ICON CTS displays.

I will report more once I can get to the dealer. If using [Evinrude ICON II EST PREMIUM] remote controls with either the [Evinrude ICON 7.0 CTS or ICON 4.3 CTS displays] the user can configure the [analog inputs of the ICON II PREMIUM EST remote controls to be used for] two fuel tanks and two oil ta...

I realize there is nothing wrong with the [ICON II BASIC EST Concealed Side Mount] controls. [Here I have deleted a long narration about the fluid tank level senders and displays that went over the same preconfigured INSTANCE settings that occur with certain Evinrude devices that have inputs for ana...

There is power on [the] drop [cable that connects to the fluid level NMEA-2000 converter]. I hope [the fluid level NMEA-2000 convertor] just needs to be turned on [by using EV-Diagnostic Version 6 software]. The [Evinrude ICON 7.0 CTS] says those four inputs (two fuel and two oil) are sourced from t...

The only [NMEA-2000 network fluid tank level] sensor my [ICON 7.0 CTS] sees is the [under-cowling] engine oil tank.

I have the [ICON II BASIC EST] control for G2. It does not have the four analog inputs for sure. I wish it did--that would be simple.

Do the numbers that are highlighted on my [tank level] network adapter matter in the INSTANCE setting? Or is it still INSTANCE=4?

Yes, my dealer is great.


I just want to make sure we have all parts needed to fix the few problems I have when I make the three-hour drive to fix it. Thanks for your help

I just looked again at the network [device] that was connected to the [resistive] fluid tank level sensor; [the network device] does have a little [housing] (as I see on-line for part number 768916). [The network device] has a sticker with boxes highlighted "fuel" and "zero" and ...

That is a lot of information and I appreciate it. We’ll start with the concealed side mount. I believe i have part number 5010252 but the control box itself has part number 5009752 on a sticker. There is no fuel level gauge wire coming off of that box like the installation and pre delivery guide say...

Hello all. I am the proud new owner of a new Evinrude 200 H.O. G2 with the ICON 7.0 CTS or Color Touch Screen display. I have all the documentation for rigging. [The principal problem and focus of discussion of this thread:] My dealer hooked a fuel [tank level] sender to the network: It doesn't work...