CONTINUOUSWAVE

I have TRIM data on the ICON Pro RPM gauge! I calibrated [the engine EMM for the TRIM function] with the [EV-Diagnostics] software. Then ran the engine to check data like water pressure and engine temperature from the engine getting to the gauge; the gauge showed those data. Then I did the Master Re...

I have a new Garmin unit connected to the [boat’s NMEA-2000] network. I'll try that [display] and check for engine [TRIM] data.

Update I installed the 47-Ohm resistor. I replaced the trim sender. After performing the calibration procedure with EV-Diagnostic software, and when using the EV-Diagnostics software I was able to watch the value of TRIM change from 0 to 100 as the engine trim changed. Also, on the ICON Pro RPM gaug...

I’m trying to follow them but I don’t understand wiring in the [resistor] when I’m using the [NMEA-2000] source not the analog source.

ok, finally today I installed a new trim sender to rule that out. I still have not trim showing on the gauge. Everything looks factory in the engine wiring so I can assume the sender is going to the EMM. I will look for the software to do the calibration. I'm lost on why I need to add a 47 ohm resis...

I'll have to look [at something unspecified] when I get the boat back from the shop. The white-tan wire being used is in the bundle with the ["molex' connectors] that directly plug into the [ICON Pro RPM gauge wiring harness]. [The wire harness includes] a three-wire bundle with a [VIOLET] and ...

[The resistive fuel tank level] sender’s white-tan wire [located] at the dashboard harness is connected to P1-8 [at the ICON Pro RPM gauge] with no resistor. P1-8 is configured for trim, and all other analog inputs are set to NC. Data for trim [sender] is set to Evinrude. I metered the trim sender f...

My recently purchased boat has a 2012 E-TEC 175-HP engine, installed with the MWS harness and with ICON Pro gauges. I want the engine TRIM to properly show on the ICON Pro [RPM] gauge, and then I will add an ICON Accessory two-inch TRIM gauge. I checked the wiring and the trim sender wire ( white/ta...