CONTINUOUSWAVE

For the 2013 Outrage 190, see Sheet 7 of this parts diagram from the Owner's section of Bostonwhaler.com.
There is also a parts listing for everything shown at the end of the diagrams.

http://www.bostonwhaler.com/boat_graphics/electronic_brochure/Company94/_56_10212010004672.pdf

Another product that works after wet sanding is Penetrol. It is in the paint department.
http://www.homedepot.com/p/Flood-Penetrol-1-qt-Clear-Paint-Additive-FLD4-04/100130893

Then again, it's rubrail. If it doesn't have some damage, you need to spend more time on the water. (humor!)

Two options:

--install the replacement inside the console, or

--install on the side of the console pointed down slightly (to allow water to drain)

I had this type of unit on my boat for seven years without a single problem:

Many members have gotten replacement windshields from UDP.

They did a custom order of Montauk windshields years ago that was admirable.

http://updplastics.com

Good news.

Now that she is purring like a kitten,I say get back on the water till the snow starts!

Fish--the 704 is fussy with just a clicking sound to indicate neutral. It takes time to get used to the feel. I would hate a control the locked into neutral.

They are not available.

One could fabricate something using fiberglass or even a composite material.

Another great refinement.

I would double check the rigging height. The motor looks to be mounted too low. E-TEC's like to be mounted rather high (3 holes up)

There have been several members who installed Yeti's. I would look through the old forum for comments.

Consider you will need to modify or remove/replace the cooler cleats and drill new holes.

I never had problems with the Igloo coolers in both my Outrage and Montauk.

Wow, the photos are truly great. I had gotten used to the text only board but can appreciate this new feature.

Nice to see you back.