90 Degree Rail Tee
Posted: Wed Mar 28, 2018 10:17 am
Hi, I need to buy two 90-degree rail T's for my 1967 SPORT 13. I believe the original rail is 7/8". The T needs to slide on from the end, through the curve, and then fitted in the middle of the rail.
Do I need the 7/8" T or the 1" T?
It may sound like an obvious answer but my concern is when sliding on will the 7/8" one get stuck in the curve of the rail?
This is the Tee I'm looking at from a local shop.
https://riggingshoppe.com/collections/rail-fittings/products/7-8-stainless-steel-90d-tee
Do I need the 7/8" T or the 1" T?
It may sound like an obvious answer but my concern is when sliding on will the 7/8" one get stuck in the curve of the rail?
This is the Tee I'm looking at from a local shop.
https://riggingshoppe.com/collections/rail-fittings/products/7-8-stainless-steel-90d-tee