190 Nantucket Live Well Pump: Repair or Replace

[InVision]

The live well pump [on a 2004 190 NANTUCKET] has died. The circuit breaker [trips opens] when turned on. [The circuit] has power so I think [the cause of the circuit breaker faulting] is just [a dead pump]. [Give me] suggestions to replace, to repair, or to get a different pump.

Currently the pump is a ShurFlo Bait Sentry 500. If I replace it I may get a 800 or 1100. The live well seemed to need some more flow.

Thank you

M

[jimh]

To verify that the cause of the circuit breaker faulting is from the pump, disconnect the pump from the circuit near the pump and retest. A problem in the wiring between the pump and the circuit breaker could also cause the breaker to trip open.

If the pump is the cause, I doubt there is much possibility for repair for the pump. Replacement seems likely the best way to remedy a problem in the pump.

[InVision]

Exactly how I tested it. On the bench it did the same thing. I figure a bait well pump lasting 14 years is good.

Is there something I am overlooking by going to a Bait Sentry 800 instead of the Bait Sentry 500?

Thanks

M

[InVision]

Also the inline valve is plastic from the bronze thru hull. It does not work, just slips, does not open all the way, and does not close all the way--replacing with a bronze ball valve. Why did Boston Whaler use plastic on thru-hull rigging? All the boats I have owned always used bronze. Pretty cheap from Boston Whaler.

M

IMG_0706.jpeg (43.43 KiB) Viewed 2883 times

[InVision]

For the record I installed a 800 Bait Sentry and Bronze Shut off valve. I also replaced the 2amp breaker with a Blue Seas 5amp as directions indicated. Got plenty of pressure in the well and my plan is to install a two way valve in line and put a raw water spray hose in engine well.

M

IMG_0718.JPG (99.65 KiB) Viewed 2850 times