93 Whaler turning in to a bit of a project.
Hoping for some help here. Rebuilding trim and tilt. I could not get the caps off of the assembly to save my life, so a friend took it to his shop. Non Boating. The techs pulled all three caps (2 trim 1 tilt).
Here is the problem.
On the larger middle tilt cylinder, when I opened ups the bag, the top slipped and hit the bottom of the boat. A mini explosion of springs and ball bearings occurred. I cannot find any diagrams that show me how to properly reassemble the spring and bearings. I believe I got them all.
Any help here? Anyone have a diagram? I have no idea how to position the bearings and springs back in to the housing. Every diagram I see assumes the housing has the bearings and springs installed. I am assuming they are some kind of valve set up to allow fluid to flow. I am so close to finishing what I thought was a simple project.
Would love to get this thing in the water for fathers day.
93 Yamaha 50 Tilt assembly -Ball Bearings and Spings
Re: 93 Yamaha 50 Tilt assembly -Ball Bearings and Spings
Is this what you are looking for? I had to guess on model #.
https://www.simyamaha.com/category_s/12913.htm?year=14&model=715&part-category=53
If it is not, I would call Andy at SIM Yamaha for help on the diagrams. He might not be able to send you one, but may be able to describe it. Worth a shot.
https://www.simyamaha.com/Contact_Us_s/14.htm
https://www.simyamaha.com/category_s/12913.htm?year=14&model=715&part-category=53
If it is not, I would call Andy at SIM Yamaha for help on the diagrams. He might not be able to send you one, but may be able to describe it. Worth a shot.
https://www.simyamaha.com/Contact_Us_s/14.htm
1992 Outrage 17
2019 E-TEC 90
2018 LoadRite 18280096VT
Member since 2003
2019 E-TEC 90
2018 LoadRite 18280096VT
Member since 2003