I am pulling off the rub rail [of a classic Boston Whaler boat (unidentified)]. What can I do about the ends of the rivets?
Some [prior discussions on this topic recommended to] push [the old rivet] back in to the foam, and fill the hole.
Is this the best way to do this?
Or, [should the old rivet be ripped] out?
And then fill a slightly bigger hole?
Rub Rail Rivet Fastener Removal
Re: Rivet removal / rub rail
Drill out the center part of the rivet. Push in the interior bit. Seal the hole with MarineTex.
1992 Outrage 17
2019 E-TEC 90
2018 LoadRite 18280096VT
Member since 2003
2019 E-TEC 90
2018 LoadRite 18280096VT
Member since 2003
Re: Rub Rail Rivet Fastener Removal
Thanks, simple is usually the best way.