Wiring new navigation lamp

Electrical and electronic topics for small boats
dleopoldi914
Posts: 34
Joined: Thu Nov 09, 2017 12:57 pm

Wiring new navigation lamp

Postby dleopoldi914 » Thu Oct 25, 2018 9:24 am

[To replace the original white all-round lamp,] I purchased a [new white all-round pole lamp] from West Marine. This lamp's wires are red and black.

Q1 : Can I simply just cut [the electrical wiring now on the boat] where the [existing two-pole electrical connector for the pole lamp is], then connect the black [wire on the boat circuit] to the black [wire on the new lamp] and the white [wire on the boat circuit] to the red [wire on the new lamp] and remount the lamp?

Q2: Will this work?

Q3: Can I just buy a two-pole connector and splice it into the circuit?

jimh
Posts: 6901
Joined: Fri Oct 09, 2015 12:25 pm
Location: Michigan, Lower Peninsula
Contact:

Re: Wiring new navigation lamp

Postby jimh » Fri Oct 26, 2018 8:50 am

A1: Yes, assuming the new lamp has an incandescent light bulb; polarity won't matter.
A2: Yes
A3: Yes; having an electrical disconnect for the pole lamp will make it much simpler to remove the pole lamp from the mounting fixture when the lamp is not needed.

[Because the topic of this discussion is small boat electrical wiring, this thread has been moved to the SMALL BOAT ELECTRICAL discussion.]