Forum: WHALER
  ContinuousWave
  Whaler
  Moderated Discussion Areas
  ContinuousWave: The Whaler GAM or General Area
  Bennett or Lenco?

Post New Topic  Post Reply
search | FAQ | profile | register | author help

Author Topic:   Bennett or Lenco?
phatwhaler posted 07-01-2002 04:03 PM ET (US)   Profile for phatwhaler   Send Email to phatwhaler  
I am interested in installing some trim tabs on my OR. I know that Bennett tabs were a factory option. I have plenty of experience with Bennett tabs, but none with the Lenco's. The Lenco tabs seem to be more desireable since there are no hydraulic lines and fluid, etc.. If anyone has any input concerning this apparent innovation in trim tabs, I would apprectiate the info.

Phatwhaler out.

kingfish posted 07-01-2002 04:35 PM ET (US)     Profile for kingfish  Send Email to kingfish     
I prefer Lenco's, and have them on both my Outrage 22 and my Parker 2520. There has been a *lot* of discussion in the repairs/mods forum (which is where you probably ought to post this question anyway) about the pros and cons of each mfr., and you should probably search that section pretty thoroughly.

If you still have questions after you peruse the earlier posts, e-mail me directly and I'll be happy to go into whatever detail you like. In fact you can e-mail me directly even if you don't review the earlier data.

kingfish

OutrageMan posted 07-01-2002 06:00 PM ET (US)     Profile for OutrageMan  Send Email to OutrageMan     
I have had Bennets, and now have Lenco's on my Bertram. For my use, I think Lencos are the better product; faster response, easier installation.

Brian

Post New Topic  Post Reply
Hop to:


Contact Us | RETURN to ContinuousWave Top Page

Powered by: Ultimate Bulletin Board, Freeware Version 2000
Purchase our Licensed Version- which adds many more features!
© Infopop Corporation (formerly Madrona Park, Inc.), 1998 - 2000.