Moderated Discussion Areas
  ContinuousWave: Whaler Marketplace
  CMC power Tilt / Trim Jackplate for up to 130hp

Post New Topic  Post Reply
search | FAQ | profile | register | author help

Author Topic:   CMC power Tilt / Trim Jackplate for up to 130hp
jeffs22outrage posted 05-12-2008 11:18 PM ET (US)   Profile for jeffs22outrage   Send Email to jeffs22outrage  

I just removed this unit this evening from my "new to me" Newport. The boat had this unit on it as the old Evinrude did not have the OEM tilt and trim that was optional at that time. I have since gotten an OEM unit to install and do not want this. The previous owner stated it worked just fine, however, I never tested it before I purchased the boat. I only ran the motor on a hose as it was winter. Then as soon as I got it home I start pulling the boat apart.

You can see it installed in the images here. ?start=all

Here are some of it off the boat.

This is the CMC PT 130 and does not have the optional gauge. It is good for motors up to 130hp. This unit was also never used in any saltwater. New they go for $500+. Make me a real offer if you would like it and be sure include shipping (it's heavy) in the offer. I clipped all of the wires with the connections still intact so it would make rewiring easier. I also have an owners manual and installation instructions as well I believe.

superdave_gv posted 05-13-2008 08:23 AM ET (US)     Profile for superdave_gv  Send Email to superdave_gv     

The "New to me" Cohasset in Georgia sent you an email.

Post New Topic  Post Reply
Hop to:

Contact Us | RETURN to ContinuousWave Top Page

Powered by: Ultimate Bulletin Board, Freeware Version 2000
Purchase our Licensed Version- which adds many more features!
© Infopop Corporation (formerly Madrona Park, Inc.), 1998 - 2000.