Forum: WHALER
  ContinuousWave
  Whaler
  Moderated Discussion Areas
  ContinuousWave: Whaler Repairs/Mods
  In Montauk console, 12 volt bus bar attached with rivets?

Post New Topic  Post Reply
search | FAQ | profile | register | author help

Author Topic:   In Montauk console, 12 volt bus bar attached with rivets?
DaveIsaacs posted 06-19-2002 03:19 PM ET (US)   Profile for DaveIsaacs   Send Email to DaveIsaacs  
I am replacing the wood behind my console instruments (1979 Montauk).
I noticed that the 12 volt bus bar is not
attached with screws but appears to be attached with rivets.
I need to take everything off the old wood and attach it all to the new wood.
Is there any way to remove the bus other than drilling out the old rivets?

Any help would be greatly appreciated,
-Dave-

JBCornwell posted 06-19-2002 05:12 PM ET (US)     Profile for JBCornwell  Send Email to JBCornwell     
Not that I know of, Dave. I drilled out the rivets and replaced them with brass countersunk screws.

Good luck.

Red sky at night. . .
JB :)

DaveIsaacs posted 06-19-2002 05:18 PM ET (US)     Profile for DaveIsaacs  Send Email to DaveIsaacs     
OK - JB, thanks very much.
-Dave-

Post New Topic  Post Reply
Hop to:


Contact Us | RETURN to ContinuousWave Top Page

Powered by: Ultimate Bulletin Board, Freeware Version 2000
Purchase our Licensed Version- which adds many more features!
© Infopop Corporation (formerly Madrona Park, Inc.), 1998 - 2000.