Forum: WHALER
  ContinuousWave
  Whaler
  Moderated Discussion Areas
  ContinuousWave: Whaler Repairs/Mods
  Exact measurement for Decal placement

Post New Topic  Post Reply
search | FAQ | profile | register | author help

Author Topic:   Exact measurement for Decal placement
DaveNJ posted 09-04-2002 08:00 AM ET (US)   Profile for DaveNJ   Send Email to DaveNJ  
RE: Exact measurement for Decal placement:
Would someone with an original 1960's 13' whaler (preferably original faded decal for exact factory decal location) please take some measurements for me ?
1) From the bottom of the rubrail to the top of the decal =
2) From the end of the transom edge to the left bottom edge of the decal =

thanks very much.
Dave

AC posted 09-04-2002 02:32 PM ET (US)     Profile for AC  Send Email to AC     
Dave,
My 13' is a 1963 with original decals. My rub rail is temporarily off, so I measured from the highest edge on the side, which may be approx. 3/8 above the lower edge of a rub rail. In other words, I slapped a ruler against the side, and it would tuck behind your rub rails lower leading edge.
1) 2 7/8" from under gunnel to top of "B" on decal.
2) 10 7/8" on Starboard side, but 11 5/8" on Port side, from the end of the transom to the REAR bottom edge of the decal. Don't know why the variance from one side to the other on my hull.?
Adam
DaveNJ posted 09-04-2002 03:25 PM ET (US)     Profile for DaveNJ  Send Email to DaveNJ     
Thanks very much Adam.

Dave

Post New Topic  Post Reply
Hop to:


Contact Us | RETURN to ContinuousWave Top Page

Powered by: Ultimate Bulletin Board, Freeware Version 2000
Purchase our Licensed Version- which adds many more features!
© Infopop Corporation (formerly Madrona Park, Inc.), 1998 - 2000.