Forum: WHALER
  ContinuousWave
  Whaler
  Moderated Discussion Areas
  ContinuousWave: Whaler Repairs/Mods
  Non-Whaler Pilot Seat

Post New Topic  Post Reply
search | FAQ | profile | register | author help

Author Topic:   Non-Whaler Pilot Seat
gcl posted 01-22-2003 04:51 PM ET (US)   Profile for gcl   Send Email to gcl  
I just purchased a used 1971 Nauset. The pilot seat is a replacement: non-Whaler. I have a question regarding the importance of the placement of the securing hardware. The replacement equipment is not as wide as the original and the mounting plates do not lineup with the location of the originals. Should I be concerned with if the mounting plates/fasteners are set into the subsurface wood? Anything else I should be concerned about ?
doobee posted 01-22-2003 07:56 PM ET (US)     Profile for doobee  Send Email to doobee     
You definitely have to attach mounting screws into wood, or they will strip out.

You can get a wood location diagram from whaler. Make sure you have the serial number that is stenciled in the splashwell.

gcl posted 01-23-2003 03:49 PM ET (US)     Profile for gcl  Send Email to gcl     
thanks
lhg posted 01-23-2003 07:35 PM ET (US)     Profile for lhg    
The wood locating drawing is shown in the reference section.
Tom W Clark posted 01-23-2003 07:39 PM ET (US)     Profile for Tom W Clark  Send Email to Tom W Clark     
http://continuouswave.com/whaler/reference/16-17/graphics/16Wood.jpeg

Post New Topic  Post Reply
Hop to:


Contact Us | RETURN to ContinuousWave Top Page

Powered by: Ultimate Bulletin Board, Freeware Version 2000
Purchase our Licensed Version- which adds many more features!
© Infopop Corporation (formerly Madrona Park, Inc.), 1998 - 2000.