Forum: WHALER
  ContinuousWave
  Whaler
  Moderated Discussion Areas
  ContinuousWave: Whaler Repairs/Mods
  Repairing Drilled Holes on Cavitation Plate

Post New Topic  Post Reply
search | FAQ | profile | register | author help

Author Topic:   Repairing Drilled Holes on Cavitation Plate
whalerajm posted 08-11-2003 10:46 AM ET (US)   Profile for whalerajm   Send Email to whalerajm  
I want to fill/repair holes on cavitation plate on my 90 HP Evinrude....The holes are from Trolling Plate/HydroFoil combo that didn't work...

What is best material to use? Any how to advise would be appreciated.

RCS posted 08-11-2003 12:37 PM ET (US)     Profile for RCS  Send Email to RCS     
Go to the Continuous Wave table of contents and look under "maintenance logs", Jimh has a very handy story written about this exact repair. He's using epoxy.
Good luck.
lhg posted 08-11-2003 03:04 PM ET (US)     Profile for lhg    
I haven't read Jim's article, but grey Marine Tex epoxy, for metals, is an excellent material to use, and very easy to wrok with.
whalerajm posted 08-11-2003 04:28 PM ET (US)     Profile for whalerajm  Send Email to whalerajm     
Thanks! I found article in "Maintenance" with step by step instructions including pictures...

Post New Topic  Post Reply
Hop to:


Contact Us | RETURN to ContinuousWave Top Page

Powered by: Ultimate Bulletin Board, Freeware Version 2000
Purchase our Licensed Version- which adds many more features!
© Infopop Corporation (formerly Madrona Park, Inc.), 1998 - 2000.