Forum: WHALER
  ContinuousWave
  Whaler
  Moderated Discussion Areas
  ContinuousWave: Whaler Repairs/Mods
  late 70's Johnson 55

Post New Topic  Post Reply
search | FAQ | profile | register | author help

Author Topic:   late 70's Johnson 55
SSWhaler posted 04-13-2004 01:59 PM ET (US)   Profile for SSWhaler   Send Email to SSWhaler  
I just aquired one of these and was wondering if anyone knew of a good OMC reference site? Mainly I wanted to see if you can add tilt/trim.
Florida15 posted 04-13-2004 02:54 PM ET (US)     Profile for Florida15  Send Email to Florida15     
You can put on a CMC T&T for $439. See the Cabela's website for details.
SSWhaler posted 04-13-2004 09:58 PM ET (US)     Profile for SSWhaler  Send Email to SSWhaler     
Thanks. I am aware of the CMC setup, but would prefer not to go that route if I can use a stock setup. Does anyone know if the trim units from the 40/50 models that were made in the mid-80s retro fit back to late 70's.
JBCornwell posted 04-13-2004 10:14 PM ET (US)     Profile for JBCornwell  Send Email to JBCornwell     
Try www.iboats.com .

Post your question in the Johnson/Evinrude Troubles and Repair Forum or the General Outboard Discussions Forum.

Lots of OMC gurus over there.

Red sky at night. . .
JB

Wayneman posted 04-23-2004 10:54 AM ET (US)     Profile for Wayneman  Send Email to Wayneman     
That's a good old used motor if it has been well cared for. I have an 1981 60hp Evinrude that runs like a top and still has most of the important parts available.

Post New Topic  Post Reply
Hop to:


Contact Us | RETURN to ContinuousWave Top Page

Powered by: Ultimate Bulletin Board, Freeware Version 2000
Purchase our Licensed Version- which adds many more features!
© Infopop Corporation (formerly Madrona Park, Inc.), 1998 - 2000.