ContinuousWave   Whaler   Moderated Discussion Areas   ContinuousWave: Whaler Repairs/Mods   morse control arm loose    search | FAQ | profile | register | author help

Author	Topic:   morse control arm loose
Blane	posted 06-21-2004 01:43 PM ET (US)         Ok newbie question for you all. The arm on my morse control throttle has become loose and will actaully pull off which makes throwing her into neutral an interesting affair. I obviously can see the allen threaded screw that is used to tighten her back down but want to make sure she is configured correctly. The Hub under the handle(almost looks like a bearing)that the handle attaches to has a bar(line)running through it. Can I simply alighn this at 12oclock and assume this is nuetral before I tighten the handle? Wahts the be4st way to go about this?
John O	posted 06-21-2004 02:30 PM ET (US)          OK is this a MT2? if so then the handle can be ajusted to any postion you want. Keep in mind that you need sufficient room to move forwrd WOT and reverse.
Blane	posted 06-21-2004 03:06 PM ET (US)             John, I would need to check the model but it is a single lever cira 1985 morse control.

Hop to: ContinuousWave: The Whaler GAM or General AreaContinuousWave: Whaler MarketplaceContinuousWave: Whaler Repairs/ModsContinuousWave: Whaler PerformanceContinuousWave: Cetacea CommentsContinuousWave: Small Boat ElectricalContinuousWave: Trips and RendezvousContinuousWave: Post-Classic WhalersMETA-Discussion