ContinuousWave   Whaler   Moderated Discussion Areas   ContinuousWave: Whaler Repairs/Mods   Binnacle Controls    search | FAQ | profile | register | author help

Author	Topic:   Binnacle Controls
Striper 15	posted 06-25-2004 06:58 AM ET (US)         Will a Morse single binnacle control/cables set from a 1992 120 hp Evinrude work with a 1992 70 hp Evinrude? Both have tilt/trim and ignition switch in the controls. Thanks!
greyg8r	posted 06-25-2004 09:56 AM ET (US)          I don't see why not. I use a Morse single binnacle with my 1982 Evinrude 90. Richard
John O	posted 06-25-2004 10:13 AM ET (US)          The Morse control will work and the cables. The engine connecters may be the only different components, but I would be surprised if you had to do little more than disconnect the engine and swap out with the other one. This is my second season using a Morse MT2 control on my 1988 Newport and it is the way to go. Solid, simple, funtional and classic.
John O	posted 06-25-2004 06:09 PM ET (US)          Oops. Sounds like you do not have the MT2. I just assummed. Either way if the control works for on motor is shoud work for the other.

Hop to: ContinuousWave: The Whaler GAM or General AreaContinuousWave: Whaler MarketplaceContinuousWave: Whaler Repairs/ModsContinuousWave: Whaler PerformanceContinuousWave: Cetacea CommentsContinuousWave: Small Boat ElectricalContinuousWave: Trips and RendezvousContinuousWave: Post-Classic WhalersMETA-Discussion