Forum: WHALER
  ContinuousWave
  Whaler
  Moderated Discussion Areas
  ContinuousWave: Whaler Repairs/Mods
  9x12", or 12x12" Trim Tabs?

Post New Topic  Post Reply
search | FAQ | profile | register | author help

Author Topic:   9x12", or 12x12" Trim Tabs?
Stephen Syrotiak posted 06-29-2009 09:02 AM ET (US)   Profile for Stephen Syrotiak   Send Email to Stephen Syrotiak  
ca 1986 22' Outrage.

Is 12x12 overkill on this boat?

TIA

Stephen

wezie posted 06-29-2009 08:11 PM ET (US)     Profile for wezie  Send Email to wezie     
If you contact Bennett they are very helpful.
Their are some charts that will help.
Where I got confused was within the choices of models.
Bennett is helpful and I imagine the other mfgs. are also.

Good Luck!

jmorgan40 posted 06-30-2009 03:06 PM ET (US)     Profile for jmorgan40  Send Email to jmorgan40     
Stephan,
I have Lenco 9x12 on my Outrage 20. I do not see any ned for 12x12. I consider that overkill.
Buckda posted 06-30-2009 04:20 PM ET (US)     Profile for Buckda  Send Email to Buckda     
....and I have 12x12 ENS Lenco's on my 18' Outrage and don't consider it overkill either....but they are VERY effective.
:)

Then again, I have twin 90 HP Motors on my 18' Outrage too....and a teak cockpit sole. Perhaps the "O" in my middle name stands for Overkill instead of Outrage...

humboldt jim posted 06-30-2009 06:58 PM ET (US)     Profile for humboldt jim  Send Email to humboldt jim     
I have the Bennett M 120s on my 22' Outrage, slotted transom with a kicker on port side. They fit/perform ideally.
acseatsri posted 06-30-2009 06:59 PM ET (US)     Profile for acseatsri  Send Email to acseatsri     
I have 12 x 12's on my 22. You can NEVER have too much tab. Larger will be more efficient.

Post New Topic  Post Reply
Hop to:


Contact Us | RETURN to ContinuousWave Top Page

Powered by: Ultimate Bulletin Board, Freeware Version 2000
Purchase our Licensed Version- which adds many more features!
© Infopop Corporation (formerly Madrona Park, Inc.), 1998 - 2000.