ContinuousWave   Whaler   Moderated Discussion Areas   ContinuousWave: Whaler Performance   Using FLO-TORQ III Hub With Stiletto Propeller    search | FAQ | profile | register | author help

Author	Topic:   Using FLO-TORQ III Hub With Stiletto Propeller
bloller	posted 08-23-2009 11:03 PM ET (US)         Can I use a Mercury FLOW-TORQ III hub kit in a Stiletto propeller designed for a Guardian hub?
bloller	posted 08-24-2009 08:09 PM ET (US)             The Stiletto web site must be down but Turbo website was up, It recommends the GUARDIAN hub but any square bore hub kit will work. Stiletto and Turbo props are both made by Precision Propeller.
L H G	posted 08-25-2009 06:18 PM ET (US)          Precision is a Yamaha owned company. Not likely they would they have licensed Mercury's patented hub system?
ratherwhalering	posted 08-25-2009 08:40 PM ET (US)             Turbo propellers are (as of 2008) square bore (Flo-Torq) hub props. For more information, see: http://continuouswave.com/ubb/Forum4/HTML/006259.html
L H G	posted 08-25-2009 09:36 PM ET (US)          [Changed TOPIC to begin a discussion of another thread. Please be reminded that discussion of the discussions themselves is not particularly of interest here on CONTINUOUSWAVE. In addition, please do not divert the topic of a thread to begin a discussion of another, different thread. --jimh]
Tom W Clark	posted 08-31-2009 10:32 AM ET (US)             Yes, you can use the Mercury Flo-Torq III hub kit with a Stiletto propeller that uses a Guardian hub kit. They are identical square bore castings, the same as BRP's TBX and PowerTech's square bore models. With few exceptions, the hub kits are all interchangeable.

Hop to: ContinuousWave: The Whaler GAM or General AreaContinuousWave: Whaler MarketplaceContinuousWave: Whaler Repairs/ModsContinuousWave: Whaler PerformanceContinuousWave: Cetacea CommentsContinuousWave: Small Boat ElectricalContinuousWave: Trips and RendezvousContinuousWave: Post-Classic Whalers