ContinuousWave   Whaler   Moderated Discussion Areas   ContinuousWave: Small Boat Electrical   Boston Whaler Boat: Installing New Wiring For Bow Navigation Lamp    search | FAQ | profile | register | author help

Author	Topic:   Boston Whaler Boat: Installing New Wiring For Bow Navigation Lamp
Binkie	posted 07-02-2007 06:17 PM ET (US)         Never seen this question addressed before. I need to run new bow light wires on my project 13 footer behind rubrail. Would the wires go between the gunwale and the L-moulding, on top of the L-moulding behind the receiver or behind the rub rail insert? Rich
gcarlil	posted 07-02-2007 08:10 PM ET (US)             I've installed two,on a 13'and a17'. On both I've installed the hard plastic receiver track, then the wiring,then the rubber rub rail. Works well. I use stainless steel pop rivets, they seem to hold better than screws. George
jimh	posted 07-02-2007 09:08 PM ET (US)             I updated the FAQ to include advice to run the wiring between the plastic receiver track and the vinyl insert.

Hop to: ContinuousWave: The Whaler GAM or General AreaContinuousWave: Whaler MarketplaceContinuousWave: Whaler Repairs/ModsContinuousWave: Whaler PerformanceContinuousWave: Cetacea CommentsContinuousWave: Small Boat ElectricalContinuousWave: Trips and RendezvousContinuousWave: Post-Classic WhalersMETA-Discussion