CONTINUOUSWAVE

I had a similar problem with my 1977 Sport 15. I ended up fabricating a plate to fix the [unspecified problem with] alignment [between two unspecified parts, perhaps the the existing engine mounting holes drilled in the hull transom and the engine mounting plate hole location created by the engine m...

I have a 1977 Sport 15 with an aftermarket center console. A SUZUKI 60-HP engine [provides good performance when the boat has a] full load. The 60-HP engine can accelerate the 1977 SPORT 15 unto hydroplane without any concern. [An unspecified boat speed at] cruise [is] easy [to obtain]. A Yamaha 70-...

A bit delayed in posting the picture. Many thanks for the suggestions. The Wise-brand seat was a perfect addition to my SPORT 15.

Jay, I have a 1977 SPORT 15 that sits and rides beautifully on a trailer made by CONTINENTAL. I purchased the trailer from B & B Trailers (904-829-6855) in Saint Augustine, Florida They have a very wide selection of trailers that are very reasonably priced, a very knowledgeable staff, and except...

Spectacular job restoring a classic. She is a real head-turner.

Nathan, I have a 1977 SPORT 15 with an aftermarket center console, so finding a suitable reasonably priced cover was a challenge. I finally ordered a cover from SealSkinCovers for under $300. It is a "made for my boat" cover that fits perfectly. I have been quite happy with the performance...

I have a 1977 SPORT 15, and I had a similar challenge when replacing my 1992 Johnson 48 with a 2022 Suzuki 50. I ended up using a 3/4-inch-thick, 4-inch-wide. 10-inch long aluminum plate. From the back of the plate holes were countersunk for bolts to accept the new pattern on the lower mounting hole...

Snowboard wrote:The hull is painted with AWLCRAFT; will the eraser wheel cause a problem?

I scraped off old decals on my 1977 Sport 15 with plastic razor blade scrappers; they worked well.

You can buy them on Amazon.

Figure 2 below shows how I installed a replacement Boston Whaler logo.

Thank you very much Phil

I am reviving a 1977 Sport 15 and am trying to determine exactly where the Whaler decals should go. I have looked at several pictures, but was curious if there are exact measurements as to the original location?

lrb59 wrote:Wise makes a seat...

Thank you for the suggestion.

Phil T wrote:Note the 15 Sport has a very small area of flat deck....install moulding on the cut line for a finished look.

Phils--thank you very much for the advice on the small flat deck area on the SPORT 15 and making a clean cut line.

[Moderator's note: this thread has been moved to THE GAM for discussion. The thread was originally posted to MARKETPLACE. The MARKETPLACE is only for posting notices of FOR-SALE or WANTED TO BUY, and it is specifically NOT for soliciting discussions. This thread has been edited to remove six posts w...