Search found 10 matches
- Tue Sep 12, 2023 3:26 pm
- Forum: REPAIRS and MODIFICATIONS
- Topic: 1984 Revenge Deck Repair
- Replies: 1
- Views: 1862
1984 Revenge Deck Repair
[Author imposed qualifying criterion for allowing replies; sorry, this forum does not impose limitations on who can participate in a thread. Your qualifiying limitations have been removed. All can reply if they have information to share.--Moderator] [This thread may be seeking advice about repairs t...
- Mon Jul 04, 2022 5:05 pm
- Forum: REPAIRS and MODIFICATIONS
- Topic: 1997 Evinrude 150-HP O-ring Dimensions
- Replies: 0
- Views: 3774
1997 Evinrude 150-HP O-ring Dimensions
Would anyone by chance know the dimensions on the 24 O-rings used on the fuel rails and balance tubes on a 1997 Evinrude 150? Or even another part number that's not listed below? I have seen the O-rings selling for $5 tp $16 each. I have not found any information on the dimensions. E150EXEUC Evinrud...
- Sat Jun 04, 2022 11:05 pm
- Forum: REPAIRS and MODIFICATIONS
- Topic: Hull Drains: Using Fiberglass Tubes to Replace Brass Tubes
- Replies: 16
- Views: 4258
Re: Hull Drains: Using Fiberglass Tubes to Replace Brass Tubes
Can fiberglass tubes be used as replacement drain tubes in saltwater with success? LONG BACK STORY I just received four feet of the [Max Gain Systems] one-inch-ID tube. I think roughing up the fiberglass tubes [and then applying a] few coats of WEST Systems epoxy would seal the tubes. If the [the fi...
- Sat Jun 04, 2022 10:23 pm
- Forum: REPAIRS and MODIFICATIONS
- Topic: 1984 REVENGE 22 CUDDY Transom Drain
- Replies: 11
- Views: 1956
Re: 1984 REVENGE 22 CUDDY Transom Drain
After 2 years I'm surprised the transom is still damp unless the wrap leaked water into your motor well. The tube in my transom drain was so bad it came out in about 3 pieces. I was fortunate that my boat was strictly used in salt water so the wood in the transom was still good. Yeah, seems either ...
- Sat May 28, 2022 10:24 am
- Forum: REPAIRS and MODIFICATIONS
- Topic: 1984 REVENGE 22 CUDDY Transom Drain
- Replies: 11
- Views: 1956
Re: 1984 REVENGE 22 CUDDY Transom Drain
My 1980 Revenge 22 had a black ball scupper at both the transom drain and the transom side of the tube between the below deck fish well and deep motor well. They were original from the factory but no longer available so I replaced the one on my transom with a T-H Marine Flow Max Ball Scupper. The t...
- Thu May 26, 2022 3:41 pm
- Forum: REPAIRS and MODIFICATIONS
- Topic: Trailer Cross Members
- Replies: 8
- Views: 1412
Re: Trailer Cross Members
I have [the same cross-member mounting brackets as the ones illustrated and discussed above] on my trailer. I was told [by someone unidentified that] the welded rod [on the mounting bracket] was to keep the cross member from turning inside the frame.
My trailer is an [all floppy] roller trailer.
My trailer is an [all floppy] roller trailer.
- Thu May 26, 2022 11:53 am
- Forum: REPAIRS and MODIFICATIONS
- Topic: 1984 REVENGE 22 CUDDY Transom Drain
- Replies: 11
- Views: 1956
Re: 84 Whaler Revenge Cuddy 22 transom drain
Thanks Phil.
The water line is high above the drain. I have never seen a scupper that low.
I am going to replace [something] with new drain tube and skip the scupper--unless anyone has a good reason to have it in the first place since it gets plugged from inside.
The water line is high above the drain. I have never seen a scupper that low.
I am going to replace [something] with new drain tube and skip the scupper--unless anyone has a good reason to have it in the first place since it gets plugged from inside.
- Thu May 26, 2022 10:47 am
- Forum: REPAIRS and MODIFICATIONS
- Topic: 1984 REVENGE 22 CUDDY Transom Drain
- Replies: 11
- Views: 1956
Re: 84 Whaler Revenge Cuddy 22 transom drain
The illustration below shows what is left of a scupper. https://i.ibb.co/n75nCjB/PXL-20220526-144748411.jpg Are scuppers commonly mounted over transom drains that far under the water line? LINK TO VENDOR SITE SHOWING A BALL FLOAT VALVE FOR A SCUPPER https://www.boatoutfitters.com/flow-max-ball-scupp...
- Thu May 26, 2022 10:20 am
- Forum: REPAIRS and MODIFICATIONS
- Topic: REVENGE 22 Trailer Bunk Arrangment
- Replies: 3
- Views: 933
REVENGE 22 Trailer Bunk Arrangment
The SEALION trailer that came with my [REVENGE 22] boat had rollers. All was well until one popped through the boat. I repaired that damage. I removed the rollers and bolted carpeted 2x6 bunks, making fours boards for the boat to sit on, and one keel roller in the front. I am not happy with the outc...
- Thu May 26, 2022 10:17 am
- Forum: REPAIRS and MODIFICATIONS
- Topic: 1984 REVENGE 22 CUDDY Transom Drain
- Replies: 11
- Views: 1956