CONTINUOUSWAVE

Posted: **Mon Nov 03, 2025 6:53 am**

Q1: where can drawings be found that have sufficient detail to allow machining of Delrin or HDPE replacement parts for the two components of the seat shown below in Figure 1 of a [unidentified model year] OUTRAGE 17 II?

: Fig. 1. The two components circled in red lines are the items for which drawings are being sought to allow duplication.; seatInProfileView.jpg (30.05 KiB) Viewed 433 times

Posted: **Tue Nov 04, 2025 9:49 am**

Apparent in Figure 1 are the two components you are asking about.

Q2: Why can't you use the existing components as templates to make replacements?

Posted: **Mon Dec 01, 2025 10:38 am**

Hi Jim,

I could, but I keep my boat about 300 miles from where I live, and only get there on holidays. I was hoping to make the parts before I next went there, but Plan B is to measure them next time and then it will all be fixed the time after that...
Thanks,

CONTINUOUSWAVE

Detailed Drawings of Seat Components for OUTRAGE 17 II

Detailed Drawings of Seat Components for OUTRAGE 17 II

Re: Detailed Drawings of Seat Components for OUTRAGE 17 II

Re: Detailed Drawings of Seat Components for OUTRAGE 17 II