CONTINUOUSWAVE

[Give me a source for a replacement through-hull drain tube] for a 2004 190 Nantucket.

I believe the other [through-hull drains on the boat were made by] Perko.

I am having no luck [finding a replacement drain tube].

I ordered my 2004 Nantucket 190 through-hull fittings from Nauset Marine:

https://www.nausetmarine.com/

Very helpful information. Thank you.

Called Nauset Marine and they were admirable. Got what I needed and some other parts and they are being shipped today. Thanks for the recommendation.

I ordered mine through Sue Lodel but it is not yet installed.
If any of you would share your installation experiences; I would be most grateful.

Mas -

My personal preference is to coat the entire tunnel in sealant or epoxy. Using a long art brush and a narrowed paint stir stick has worked for me. Once cured, dry fit tube. Apply painters tape around both flanges . Apply Boat Life on inside of flange and on the hull. Use a threaded rod with wide washers and nuts to ensure a good (tight but not too tight) fit. Remove rod and tape.

Thanks Phil!