Page 1 of 1
BECKSON Clear Pry-out Deck Access Plate: Removing Fogging and Scratches
Posted: Wed May 25, 2022 2:02 pm
by Don SSDD
How can fogging and scratches in a BECKSON clear circular pry-out deck access plate be removed?
I tried Plastx by Meguiar's, but it doesn’t work on this material.
Thanks,
Don
Re: BECKSON Clear Pry-out Deck Access Plate: Removing Fogging and Scratches
Posted: Wed May 25, 2022 2:11 pm
by jimh
The BECKSON clear pry-out deck access plates used typically to cover the fuel tank access point where the fuel tank level gauge is located can still be obtained from the OEM supplier for $38. That includes a new surround ring and the pry-out plate. I do not believe BECKSON sells just the clear pry-out plate.
See the article in the REFERENCE SECTION on the TOPIC of
Original Equipment Manufacturers and
Recommended Vendorshttps://continuouswave.com/whaler/refer ... tml#pryout
Re: BECKSON Clear Pry-out Deck Access Plate: Removing Fogging and Scratches
Posted: Wed May 25, 2022 2:22 pm
by Don SSDD
Very good Jim, that is a great deal for $38 these days. Thanks, Don
Re: BECKSON Clear Pry-out Deck Access Plate: Removing Fogging and Scratches
Posted: Wed May 25, 2022 3:35 pm
by Phil T
Don - Consider wet sanding?
Re: BECKSON Clear Pry-out Deck Access Plate: Removing Fogging and Scratches
Posted: Wed May 25, 2022 8:36 pm
by Don SSDD
What’s the process Phil? Not experienced but can take a crack at it.
Re: BECKSON Clear Pry-out Deck Access Plate: Removing Fogging and Scratches
Posted: Thu May 26, 2022 11:04 am
by Phil T
It is similar to woodworking.
Start with a grit and work finer. I would start at 1000 grit, then step up to 1500 and then finish at 2000.
Re: BECKSON Clear Pry-out Deck Access Plate: Removing Fogging and Scratches
Posted: Thu May 26, 2022 1:00 pm
by Don SSDD
Thanks Phil, I’ll give it a try.