BEEP BEEP BEEP from Mercury Outboard
Posted: Sun May 15, 2016 11:11 am
While testing my boat at a lake I noticed [the 2001 Mercury Saltwater Series 200-HP outboard engine warning system's aural alert] was constantly beeping--BEEP--BEEP--BEEP.
[Seeks] ideas [on how to interpret the alarm sounding].
-----
[What follows is a very detailed, long, back story about how the alarm came to sound--jimh]
[I] shut-down the [2001 Mercury Saltwater Series 200-HP outboard engine]. I checked oil tank and it was full. [I] felt [the engine block cylinder] heads, and [I] could keep my hands on them for five seconds.
[With the engine's] cover on, I started up [the 2001 Mercury Saltwater Series 200-HP outboard engine] and [advanced the engine throttle to produce a boat speed of] trolling speed. The alarm aural alert [went] BEEP BEEP BEEP.
Then nothing.
I [advanced the engine] throttle and [the aural alert sound] was a constant BEEEEEEEEEP.
I immediately [reduced throttle]. [The aural alert sound] went away but [the aural alert sound] beeped twice within 20 seconds.
Shut down [the 2001 Mercury Saltwater Series 200-HP outboard engine].
Started [the 2001 Mercury Saltwater Series 200-HP outboard engine]. I smelled oil in exhaust. I [returned to the dock at slow speed]. [The aural alert sounder] beeped twice.
At shore [I] unplugged [an unidentified electrical conductor from] the temperature sensor, grounded [this unidentified electrical conductor] and [the aural alert sound] beeped continuously.
[Next I] unscrewed oil tank, moved float back and forth, and [unclear, perhaps meant oil tank or float or engine or alarm] works.
Started [unclear]. I [pointed] a [thermometer gun device] [at] [the 2001 Mercury Saltwater Series 200-HP outboard engine] and [the reading on the thermometer gun device] was between 140 to 160.
I did [unclear, perhaps meant "installed a new"] a water pump. Both [thermostat valve] and poppet valve last week [unclear what was done with them].
Took [the 2001 Mercury Saltwater Series 200-HP outboard engine] back on water. [In an area with] wake zone speed, [the aural alert sounder made a] BEEP-BEEP.
[Returned to dock] Sat there. [I] trailered my father's [boat].
Then we were going to go out on my boat with the heat temp gun and see what temp was [when] running.
We went out.
The boat drove got to 25-MPH; there was no alarm. Keep [the boat speed] there around the entire lake twice, [a distance of] about 6 miles, and still no alarm.
Gradually brought up [throttle]: still going; no alarm.
[At wide-open throttle and] humming along: no alarm.
Maybe I was [not] hearing the occasion BEEP because of wind. [Reduced throttle until boat speed was at] cruise speeds: no alarm.
[In areas with ] wake zone speeds: no alarm.
Back to WOT: no alarm.
Probably just under 10-miles of running that motor, and no damn alarm!
I sit in wonder without an explanation.
By the way i bought the boat and motor over the Winter.
I guess [the boat and motor] sat the two previous seasons without being used.
I did drain all [fuel] I could. I did use a turkey baster to check for sludge at bottom of both oil tanks. There was no sludge and no water.
[Seeks] ideas [on how to interpret the alarm sounding].
-----
[What follows is a very detailed, long, back story about how the alarm came to sound--jimh]
[I] shut-down the [2001 Mercury Saltwater Series 200-HP outboard engine]. I checked oil tank and it was full. [I] felt [the engine block cylinder] heads, and [I] could keep my hands on them for five seconds.
[With the engine's] cover on, I started up [the 2001 Mercury Saltwater Series 200-HP outboard engine] and [advanced the engine throttle to produce a boat speed of] trolling speed. The alarm aural alert [went] BEEP BEEP BEEP.
Then nothing.
I [advanced the engine] throttle and [the aural alert sound] was a constant BEEEEEEEEEP.
I immediately [reduced throttle]. [The aural alert sound] went away but [the aural alert sound] beeped twice within 20 seconds.
Shut down [the 2001 Mercury Saltwater Series 200-HP outboard engine].
Started [the 2001 Mercury Saltwater Series 200-HP outboard engine]. I smelled oil in exhaust. I [returned to the dock at slow speed]. [The aural alert sounder] beeped twice.
At shore [I] unplugged [an unidentified electrical conductor from] the temperature sensor, grounded [this unidentified electrical conductor] and [the aural alert sound] beeped continuously.
[Next I] unscrewed oil tank, moved float back and forth, and [unclear, perhaps meant oil tank or float or engine or alarm] works.
Started [unclear]. I [pointed] a [thermometer gun device] [at] [the 2001 Mercury Saltwater Series 200-HP outboard engine] and [the reading on the thermometer gun device] was between 140 to 160.
I did [unclear, perhaps meant "installed a new"] a water pump. Both [thermostat valve] and poppet valve last week [unclear what was done with them].
Took [the 2001 Mercury Saltwater Series 200-HP outboard engine] back on water. [In an area with] wake zone speed, [the aural alert sounder made a] BEEP-BEEP.
[Returned to dock] Sat there. [I] trailered my father's [boat].
Then we were going to go out on my boat with the heat temp gun and see what temp was [when] running.
We went out.
The boat drove got to 25-MPH; there was no alarm. Keep [the boat speed] there around the entire lake twice, [a distance of] about 6 miles, and still no alarm.
Gradually brought up [throttle]: still going; no alarm.
[At wide-open throttle and] humming along: no alarm.
Maybe I was [not] hearing the occasion BEEP because of wind. [Reduced throttle until boat speed was at] cruise speeds: no alarm.
[In areas with ] wake zone speeds: no alarm.
Back to WOT: no alarm.
Probably just under 10-miles of running that motor, and no damn alarm!
I sit in wonder without an explanation.
By the way i bought the boat and motor over the Winter.
I guess [the boat and motor] sat the two previous seasons without being used.
I did drain all [fuel] I could. I did use a turkey baster to check for sludge at bottom of both oil tanks. There was no sludge and no water.