Source for Anchor Locker Drain Replacement

Repair or modification of Boston Whaler boats, their engines, trailers, and gear
hodgsonjl
Posts: 5
Joined: Wed May 19, 2021 10:55 pm

Source for Anchor Locker Drain Replacement

Postby hodgsonjl » Sun Jun 13, 2021 7:11 am

[Give me a source for a replacement through-hull drain tube] for a 2004 190 Nantucket.

I believe the other [through-hull drains on the boat were made by] Perko.

I am having no luck [finding a replacement drain tube].

roundle1979
Posts: 95
Joined: Thu Jun 13, 2019 11:10 am

Re: Source for Anchor Locker Drain Replacement

Postby roundle1979 » Sun Jun 13, 2021 9:43 am

I ordered my 2004 Nantucket 190 through-hull fittings from Nauset Marine:

https://www.nausetmarine.com/
Attachments
190-Nantucket-Thru-Hulls-Assembly-Parts-List-2004.pdf
(48.66 KiB) Downloaded 237 times
190-Nantucket-Thru-Hulls-Assembly-2004.pdf
(88.85 KiB) Downloaded 202 times
2004 Nantucket 190 w/ Mercury Optimax 135

hodgsonjl
Posts: 5
Joined: Wed May 19, 2021 10:55 pm

Re: Source for Anchor Locker Drain Replacement

Postby hodgsonjl » Mon Jun 14, 2021 8:33 am

Very helpful information. Thank you.

hodgsonjl
Posts: 5
Joined: Wed May 19, 2021 10:55 pm

Re: Source for Anchor Locker Drain Replacement

Postby hodgsonjl » Mon Jun 14, 2021 1:29 pm

Called Nauset Marine and they were admirable. Got what I needed and some other parts and they are being shipped today. Thanks for the recommendation.

Masbama
Posts: 355
Joined: Thu Oct 15, 2015 8:33 pm
Location: Mobile, Al

Re: Source for Anchor Locker Drain Replacement

Postby Masbama » Tue Jun 15, 2021 8:22 am

I ordered mine through Sue Lodel but it is not yet installed.
If any of you would share your installation experiences; I would be most grateful.

User avatar
Phil T
Posts: 2602
Joined: Thu Oct 22, 2015 6:08 pm
Location: Was Maine. Temporarily Kentucky

Re: Source for Anchor Locker Drain Replacement

Postby Phil T » Tue Jun 15, 2021 11:40 am

Mas -

My personal preference is to coat the entire tunnel in sealant or epoxy. Using a long art brush and a narrowed paint stir stick has worked for me. Once cured, dry fit tube. Apply painters tape around both flanges . Apply Boat Life on inside of flange and on the hull. Use a threaded rod with wide washers and nuts to ensure a good (tight but not too tight) fit. Remove rod and tape.
1992 Outrage 17
2019 E-TEC 90
2018 LoadRite 18280096VT
Member since 2003

Masbama
Posts: 355
Joined: Thu Oct 15, 2015 8:33 pm
Location: Mobile, Al

Re: Source for Anchor Locker Drain Replacement

Postby Masbama » Wed Jun 16, 2021 8:15 am

Thanks Phil!