ICON Pro Gauge Firmware Version

Information about Evinrude I-Command, ICON Pro, and ICON Touch Color Displays
jimh
Posts: 4903
Joined: Fri Oct 09, 2015 12:25 pm
Location: Michigan, Lower Peninsula
Contact:

ICON Pro Gauge Firmware Version

Postby jimh » Fri Nov 17, 2017 10:19 am

To discover the version of firmware that is being used to operate an Evinrude ICON Pro RPM gauge, perform the following procedure:

    --from the normal gauge operating mode, hold the MODE button down for three seconds;
    --the display branches to the top menu selection;
    --using the UP and DOWN arrows, scroll to the EDIT MENU choice; hold the MODE button down for three seconds;
    --the display branches to the EDIT menu selection;
    --using the UP and DOWN arrows, scroll to the SYSTEM INFO choice; hold the MODE button down for three seconds;
    --the display branches to the SYSTEM INFO menu;
    --using the UP and DOWN arrows, scroll to the SOFTWARE choice; hold the MODE button down for three seconds;
    ----the gauge displays the revision and date of the firmware.

To revert to normal operation, push the MENU button briefly three times.

When performing this procedure on a gauge I have (an earlier version), the displays shows:

PGFT47N 
REV A
4/27/2011