Length of fill hose and vent hose for 2007 Dauntless 180

[Tony's Legacy]

[I plan to] replace the [fuel tank inlet filler] hose and vent hose on my [2007–ALWAYS USE FOUR DIGITS FOR YEAR] 180 DAUNTLESS.

I've looked over the diagrams at

(https://www.bostonwhaler.com/content/da ... t-2007.pdf)

to see what I need, but it says to refer to drawing 01-251 for individual hose lengths. The problem is that I can't find that drawing.

Q1: [IMPUTED QUESTION] what are the lengths [and diameter and necessary USCG APPROVALS] needed for the fuel tank filler hose and the fuel tank vent hose?

Thanks

[Phil T]

It is not published.

You need to pull the hose to get the exact length or overestimate. Run a garden hose over the deck to simulate path.

[Tony's Legacy]

Thanks for the info. I'll end up estimating because I want to use the old hose to help pull the new hose through.

[jimh]

Murphy’s Law corollary: any rubber fuel hose bought cut-to-length will be too short.

[Jefecinco]

Tie a "pull string" to the old hose before pulling it out to measure it. Use the string to pull the new hose into position.