2000 Dauntless center console- Need straps for cooler seat to be held down.
2000 Dauntless center console- Need straps for cooler seat
Re: 2000 Dauntless center console- Need straps for cooler seat
How can readers help you?
Are you looking for recommendations for a vendor?
Are you looking for advice on what type of strap to buy?
Also, you do not need to write in terse sentence fragments as if you were sending a telegram to some faraway destination in 1920. If you clarify what information you are asking for, readers will be better able to help you.
Also, when you seek information about a specific Boston Whaler boat model, give the YEAR, give the MODEL FAMILY, and give rwo-digit or three-digit length descriptor.
Are you looking for recommendations for a vendor?
Are you looking for advice on what type of strap to buy?
Also, you do not need to write in terse sentence fragments as if you were sending a telegram to some faraway destination in 1920. If you clarify what information you are asking for, readers will be better able to help you.
Also, when you seek information about a specific Boston Whaler boat model, give the YEAR, give the MODEL FAMILY, and give rwo-digit or three-digit length descriptor.
Re: 2000 Dauntless center console- Need straps for cooler seat
The cooler hold-downs on our 1999 Dauntless 16 center console were rubber bungee-type cords with hooks on the ends. Bungee cords may serve as a substitute if you are unable to locate the correct cords.
Butch
-
- Posts: 9
- Joined: Fri Nov 06, 2020 10:12 am
Re: 2000 Dauntless center console- Need straps for cooler seat
I used strapping from ratchet straps over the seat and then screwed through the cut strap into the plastic of the freezer chest. Works well.
Re: 2000 Dauntless center console- Need straps for cooler seat
Unscrew the cleats on the deck and replace the bungie cord. Sold by the foot in a local hardward store. C hook to the hole in the center of the handle base.
Seal the cleat screw holes on reassembly with Boat Life and not adhesive.
Seal the cleat screw holes on reassembly with Boat Life and not adhesive.
1992 Outrage 17
2019 E-TEC 90
2018 LoadRite 18280096VT
Member since 2003
2019 E-TEC 90
2018 LoadRite 18280096VT
Member since 2003
Re: 2000 Dauntless center console- Need straps for cooler seat
I faced a similar challenge with my 2003 160 Dauntless, and ,due to the condition of the cooler, I ended up replacing it with a Yeti 45 that fit well in the space. I attached the seat pad in a similar fashion to the original and used simple nylon straps with plastic buckles to anchor it. See attached photos.
Hope this helps.
Todd
Hope this helps.
Todd