SPORT 13 Water in Hull
SPORT 13 Water in Hull
My SPORT 13 has water intrusion. The boat sat for about three years out of the water
Some of the foam [inside the Unibond] hull was saturated [presumably held water].
Q1: will [epoxy resin cure and form a bond to] wet foam?
Q2: [for epoxy resin to cure and form a bond to the foam in a Unibond hull] does the foam need to be completely dry?
Tell me how YOU would proceed [to make a repair with epoxy resin to an area of damage where the foam is holding water and is not dry]
Re: SPORT 13 Water in Hull
Aschubox wrote:Tell me how YOU would proceed [to make a repair with epoxy resin to an area of damage where the foam is holding water and is not dry]
I would dry the foam before attempting to make a bond to the foam with epoxy resin.