ContinuousWave   Whaler   Moderated Discussion Areas   ContinuousWave: The Whaler GAM or General Area   Looking for marine Metal Fabricator    search | FAQ | profile | register | author help

Author	Topic:   Looking for marine Metal Fabricator
jmorgan40	posted 08-25-2008 11:32 AM ET (US)         Need some help finding a good Marine Metal Fabricator. They are a dime a dozen near the coast but rare around the Atlanta area. I am preparing to rewire the Outrage and installing the NMEA2000 backbone. I would like someone to fabricate a wiring chase tube to run between the console and the electronics box on the t-top. I wish to eliminate the need of running the wires up through the leg of the t-top since I am running additional cables with the NMEA backbone. I have seen these before on other t-tops. It would be a 2.5” or 3” anodized aluminum tube with a flange on either end that would bolt to the bottom of the electronics box and the top of the console. Any recommendations of a fabricator a Wave member has used in the past would be appreciated. Thanks Joe
contender	posted 08-25-2008 11:41 AM ET (US)             Check out a race car place,(were they build custom cars) should be plenty around Atlanta...good luck
jmorgan40	posted 08-25-2008 01:17 PM ET (US)             Thanks, found a guy in Ft. Meyers to do it.
contender	posted 08-25-2008 01:18 PM ET (US)             Or a custom metal shop, they will do stainless and/or aluminum...good luck
jmorgan40	posted 08-25-2008 02:14 PM ET (US)             It is easier to stay with a good marine fabricator because they will know exactly what I want.

Hop to: ContinuousWave: The Whaler GAM or General AreaContinuousWave: Whaler MarketplaceContinuousWave: Whaler Repairs/ModsContinuousWave: Whaler PerformanceContinuousWave: Cetacea CommentsContinuousWave: Small Boat ElectricalContinuousWave: Trips and RendezvousContinuousWave: Post-Classic WhalersMETA-Discussion