ContinuousWave   Whaler   Moderated Discussion Areas   ContinuousWave: Whaler Repairs/Mods   covering for Montauk deck rigging tunnel    search | FAQ | profile | register | author help

Author	Topic:   covering for Montauk deck rigging tunnel
bt	posted 05-26-2008 09:04 PM ET (US)         I need to replace the covering over my 1987 Montauk rigging tunnel near the stern where the hoses etc. exit. It was rotten when I purchased. Any suggestions on type of wood or Marine lumber? bt
Casco Bay Outrage	posted 05-26-2008 09:52 PM ET (US)             One alternative to the OEM marine plywood is to buy a cheap off white plastic cutting board. Cut for size, leaving room for rigging and cut a bit off the bottom edge on the back side so it sits flush with the deck.

Hop to: ContinuousWave: The Whaler GAM or General AreaContinuousWave: Whaler MarketplaceContinuousWave: Whaler Repairs/ModsContinuousWave: Whaler PerformanceContinuousWave: Cetacea CommentsContinuousWave: Small Boat ElectricalContinuousWave: Trips and RendezvousContinuousWave: Post-Classic WhalersMETA-Discussion